Reticle library · Nightforce
Drawn to scale from Nightforce’s own specification sheet, and checked mark by mark by a person. This is the same geometry Harson Ballistics draws your holdover on.
Framed to about 12 MRAD — the part of the reticle you aim with. This reticle carries marks out to 18 MRAD; the rest sits beyond the edge of this drawing.
Drawn from Nightforce Optics, Inc.’s published specification.
In the second focal plane the subtensions are only true at one magnification — check your manual for which, and dial there before you hold.
Nightforce Mil-CF2 / Mil-CF2D Reticle Sheet (REV 0720) page 2, Mil-CF2 column, measured @ 20x, MRAD: A=16 horizontal scale, B=0.029 line, C=0.2 half-length .2 marks, D=0.6 whole-mil marks, E=0.1 gap from the dot to the lines, F=0.2 the centred marks at +/-0.2 on the vertical, G=0.2 mark pitch, H=1.0 whole-mil pitch, I=0.34 numeral height, K=0.05 illuminated centre dot, L=0.1 the half marks at +/-0.2 on the horizontal (hanging below), M=0.2 gap from the last mark to the post tip, N=0.25 and O=0.5 post. Marks alternate sides as on MIL-C: on the vertical .2/.8 left and .4/.6 right, on the horizontal .2/.8 below and .4/.6 above; whole mils centred. Vertical runs +5 to -10; no bottom or top post. Side posts are a hollow chevron (drawn here as a solid taper, tip 8.2 to 8.65) then two rails at +/-0.207 (0.087 thick) with the fine line between, then a solid bar from 9.19. Second focal plane: 20x.
Verified 9 Oct 2026 against Nightforce NF_MIL-CF2_Reticle Sheet (REV 0720, specs/nightforce/NF_MIL-CF2_Reticle_Sheet.pdf) page 2, upper (Mil-CF2) drawing, read as VECTOR. Scale fitted by least squares to 98 axis marks: 16.006 pt/mil, worst residual 0.005 mil. Every one of the 75 vertical and 80 horizontal marks the sheet draws matches the published-graduation rule in position (worst 0.019 mil) and both ends (within 0.03), side included, and every rule mark is drawn. Measured against the table: A=16, E=0.1, B drawn 0.033, M (post tip) 0.222, O 0.501, N (rail outer edge) 0.252; C, D, F, L by the mark rule; G and H by the pitch; I and are the label sizes; K the dot. Numerals read from the sheet's text layer, positions measured. Post shoulder/rail/solid positions measured (unpublished). Cross-checked by overlay against a raster of the sheet (tools/nf_wave2_lib.crosscheck). All lettered dimensions represented. Reference 20x from the sheet's 'Measured @' row.
Harson Ballistics draws this reticle at your magnification with your holdover marked on it, from your rifle, load and conditions. Works with no signal and no account.
Subtensions are published by the manufacturer and reproduced here for reference. Confirm your own dope on a range before you rely on any of it. Harson.ai is not affiliated with Nightforce.